#Vsco keys installation instructions download
Ensure the seat areas are clean and greased prior to reinstating the covers in the frame.Some newer PCs and MACs will automatically unzip the file following download you can apply this preset on your images by one click.Once cured, remove covers with a Mascot Engineering Lifting Key and strip the internal formwork.Removing covers prior to curing may result in damage. Concrete must be allowed to cure before removing the covers from the frame.The edges of the cover and frame should be visible. Screed off excess concrete and finish the surface as required.Ensure that the concrete is well compacted and the frame is fully supported.Simultaneously fill the rebate gap, frames and infill covers with concrete.This reinforcement should be installed to the engineer’s details. NOTE: For some loadings, reinforcing may be required in the rebate under the frame. Replace all keyhole plugs and boltdown covers.Check the covers for any rocking or movement and adjust packing as required. Using the marks on the frame and cover (as per above), place the covers back into the frame ensuring the top edges of the covers are level with the frame.These surfaces must be dirt and dust free.Clean the seating area of the covers and frame.For covers with ‘holes’, cover with metal sheeting or similar. Prepare internal formwork ensuring the frame will be fully supported.For 2 or 3 part covers, pack under the frame joints to prevent sagging. Pack under the cover of the frame joints until level with the finished floor.Ensure the covers are placed in a direction suitable for traffic flow (see drawing) NOTE: The frame must not protrude into the opening, Position the frame in the rebate and ensure the lifting end of the frame is not obstructed (as per ‘direction of cover removal’ drawing).For 2 or 3 part covers, mark the frame and covers to ensure they are reinstated in the same position.Remove all the keyhole plugs and boltdown bolts (if fitted) from the covers and remove the covers from the frame using Mascot Engineering Lifting Keys (see page 31 for details).See charts for recommended rebate dimensions for your cover. For details, contact 1300 885 295 Form the access pit and rebate to the size required. NOTE: Not to be used for decorative edge or multipart installation. Single, Two and Three Part Access Covers and Frame Frames may suffer twisting and damage to joints if mistreated. See drawing ‘Direction of cover removal’.Īll infill covers and frames must be filled with structural grade concrete (refer to AS3996 for further information). If there is an obstruction (wall, bollard etc), ensure the cover is positioned in a direction away from the obstruction.
The direction a cover can be removed from its frame is indicated by the cover edge with two keyholes. Covers in Multi-parts are marked and designated to a particular location in the frame and bespoke installation instructions are provided with your cover. A cover from one frame will not necessarily fit another. Mascot Engineering covers and frames are mated individually during the machining process, therefore they are not always interchangeable.
For more information on your cover, contact or 1300 885 295. The information set out on these pages is a guide only and does not take into account any site specific limitations or requirements. Installation Instructions – access covers
Class G Cast Iron Trench Grates and Frames.Custom Concrete Encased Grates and Frames.Installation Instructions – access covers.Covers to suit Boat Shaped Trade Waste Tanks.Covers to suit Flat Bottom Trade Waste Tanks.Solid Top Covers and Frames to suit GRC Pits.Installation Instructions – Water Tanks.Installation Instructions – drainage pits.
0 kommentar(er)
